Here is the promised instruction for my tea bag packaging, which I designed as a bargaining chip for the Stampin 'demo meeting in February 2011.
following material from Stampin 'I used this:
- dark and light color box
- stamp pads in the color of the darker color boxes
- stamp set "Just believe"
- Sidewalls punch
- Punch Word Window
- circle punch 1 3 / 8 inch
- Wave circle punch
- cutting machine
- self-adhesive tape
- mini glue dot
still advance to the following color choices: Which colors do you use depends of course on the colors of the used tea bag. For this tutorial I have the tea "rest" used the mark Lord Nelson from Lidl. Serve with the colors of delicate blue and navy blue. A
Variant, for example, the tea "relaxation" of the same brand that I have taken my trading items. Here are my color choice was pure vanilla and savannah.
Now it is a matter with the instructions:
Cuts the lighter color box with the cutter a strip in size 7 1 / 4 inches x 2 1 / 4 inch (for cutting use the orange using the slicer). This strip your folds then at 6.5 cm - 7 cm - 14.5 cm - 15cm (for folding the black insert use successors or with the bone folder the groove of the cutter).
As great parallel to the cutting machine from Stampin both units are on the scale provided, is the change from inch to cm no Problem dar.
Now slide the small side in the middle all the way into the side wall punch and punch (Note: Only 1x center punch, leaving the edges are!). The longer side of the wheel center to the stop in the word window punch and punch. Your strips should then look like this:
up a stamped the branch from the set of "simple faith" with the darker color below the word window punch-slot. Make sure that you can not summon up the printing on the side of the cutting edge, but on the side of the fold lines.
With Clear stamps and an acrylic block allows you to look wonderful, where the branch aufstempelt. If your wooden temple take, I would recommend you to position the use of the Stamp-A-ma-jig.
The circle stamp from the set of "simple faith" is also stamped with the darker color on a scrap piece of bright colored boxes.
punch then stamped the circle with the circle dance. I recommend it to 1 3 / 8 inch punch, since this was still a narrow light border around the stamped circle is what made a great visual effect.
The sidewalls punch is still a wave group from the dark color cardboard cut out.
the circle you can with your trusty glue Glue the circle on the dark shaft.
back to the wave group is now only the bottom part is a little bit in the red self-adhesive tape (see photo).
here depends on the longevity of the closure of the packaging on the quality of the selected adhesive. Therefore, I commend you for this, the red tape from Stampin 'self. The fact really holds bombproof.
protective film from adhesive tape and the shaft circle to place over half of the word window to the tea bag packaging that really only the lower boundary is fixed. You have to top with your finger can go under the wave cycle.
is now bent to the Strip to the fold lines and the tea bag stuck with a mini glue dot on the back from the front, so you can read the printed words in the Word window.
The large area inside can still be a little greeting written or stamped.
to seal the tea bag packaging you'll just have the edge stamped shaft between the shaft and the circular edge of the strip. The straight edge of the punch is then at the top of the circle.
The cap holds without adhesive and can be again and again-and do.
Of course you can, the tea bag packaging now according to your taste with pearls, paste stones or ribbons decorate further.
I hope you have fun at the handiwork!
soon
your Marion
0 comments:
Post a Comment